Javascript Menu by
Schenck RoTec in Malaysia

Static unbalance

Two unbalances (shown here as arrows) can have the same size and angular position and can be the same distance from the centre of gravity. The same condition results for an individual, twice as large, unbalance that acts at the centre of gravity, i.e. in this case in the middle of the rotor. If such a rotor is supported on two knife edges, it would swing until the "heavy point" was facing downwards. This means this unbalance acts even without rotation; it is therefore called "static unbalance". It causes the centre of mass to shift away from the geometric centre, which in turn causes the rotor to swing oscillate parallel to its rotational axis when it is running.

Static unbalance should be corrected in the centre of gravity plane. This is achieved by removing material at the "heavy point" or attaching material at the opposite side. Correction of static unbalance in one correction plane occurs particularly frequently in disc-shaped rotors. Therefore, vertical balancing machines are most suitable for balancing these.

If you have any questions, please contact:

Mr. Chai Yoon Chong

+603 56 50 28 09
+603 58 80 65 90

Your contact for the states of Johor and Melaka:

Mr. Cheng Y.S.

+65 9696 6398
+607 357 6286

Use of cookies
Cookies enable the best possible provision of our services. By using our pages and services you agree that we use cookies.
Link to the Schenck RoTec data protection declaration